Session Details
[P]P154~P174
Wed. Sep 18, 2024 2:00 PM - 3:30 PM JST
Wed. Sep 18, 2024 5:00 AM - 6:30 AM UTC
Wed. Sep 18, 2024 5:00 AM - 6:30 AM UTC
Poster Session Room1 Assembly Hall at Osaka Univ. Hall
[P154]Effect of Carbon Addition on Sintering Properties of β-TCP
*Kosei KAIDO1, Nobuaki SEKIDO2, Kyosuke YOSHIMI2 (1. Graduate School of Engineering, Tohoku Univ., 2. Department of Materials Science, Graduate School of Engineering, Tohoku Univ.)
[P155]Quantitative analysis of crystal structure of MAX phases by XRD measurement
*Doyeon Lee1, Jaemin Song1, Jungi Seo1, Hanjung Kwon1 (1. Jeonbuk National University)
[P156]Improvement of properties of cemented carbides using Ni based alloys as binder phases
*Jungi Seo1, Jaemin Song1, Doyeon Lee1, Hanjung Kwon1 (1. Jeonbuk National University)
[P157]Effects of low-temperature annealing on strength of Cu-Ni-Al alloy sheets
*Yuma NISHIMURA1, Yasuyuki KANENO2, Shigeo SATO3, Satoshi SEMBOSHI4 (1. Osaka Metropolitan. Univ, 2. Osaka Metropolitan. Univ, 3. Ibaraki Univ, 4. Shimane Univ)
[P158]Comparison of Mechanical Properties and Microstructure of H13 Material Manufactured by PBF Method under Different Heat Treatment Conditions
*Tae-yeong So1, Seok-won Son1 (1. Korea Institute of Industrial Technology)
[P159]Effect of Annealing on Properties of Al-Fe Alloys Produced by L-PBF Method
*Kotaro TOKUE1, Kazuhiro ISHIKAWA1, Naoki TAKATA2, Yoji MIYAJIMA1 (1. Kanazawa Univ., 2. Nagoya Univ.)
[P160]A study on the optimization of cold rolled process and annealing heat treatment condition in pure Al
*Sunki Kim1, Seunghyun Koo1, Youngkyun Kim2, Sangmin Yoon2, Seong-Ho Ha3 (1. NICELMS Co., Ltd.、2. Institute for Advanced Engineering、3. Korea Institute of Industrial Technology)
[P161]A study on the microstructure and mechanical properties of Al-8mass%Mg alloy containing a trace of Al2Ca with cold rolled process and annealing heat treatment
*Seunghyun Koo1, Sunki Kim1, Youngkyun Kim2, Sangmin Yoon2, Seongho Ha3 (1. NICELMS Co., Ltd.、2. Institute for Advanced Engineering、3. Korea Institute of Industrial Technology)
[P162]Microstructural observation of aged Al-7%Si alloys with Mg addition
*Hironari Fukushima1, Taiki Tsuchiya1, Seungwon Lee1, Susumu Ikeno2, Kenji Matsuda1 (1. University of Toyama, 2. Professor of emeritus University of Toyama)
[P163]Effect of Al addition on precipitation microstructure of Mg-Zn alloy
*Shungo TAKEHATA1, Taiki Tsuchiya1, LEE Seungwon1, Kenji Matsuda1, Susumu Ikeno2 (1. University of Toyama, 2. Professor emeritus University of Toyama)
[P164]Geometry of cooperative deformation in kink microstructure
*Haruki Kawashima1, Ryutaro Matsumura2, Tomonari Inamura2 (1. Department of Material Science and Engineering, Tokyo Institute of Technology, 2. IIR, Tokyo Institute of Technology)
[P165]Al concentration dependence of superplastic creep behavior in BCC Mg-Li-Al alloys
*Kouya Kyan1, Reina Sato2, Seita Shibata2, Hiroyuki Sato2, Takahiro Mineta2 (1. Hirosaki Univ. (Graduate student), 2. Hirosaki Univ.)
[P166]Effect of structural factor on compressive creep deformation behavior in Mg-Zn-Y alloys with multimodal microstructure
*Wataru Bando1, Daisuke Takahashi1, Naoaki Tsunekawa1, Hiroyuki Sato2, Koji Hagihara3, Michiaki Yamasaki4, Takahiro Mineta2 (1. Hirosaki Univ.(Graduate student), 2. Hirosaki Univ., 3. Nagoya Inst. of Technol., 4. Kumamoto Univ.)
[P167]Room temperature mechanical property of BCC Mg-Li-Al alloys and its control by two step aging
*Kain Ichinohe1, Seita Shibata2, Hiroyuki Sato3, Takahiro Mineta3 (1. Hirosaki Univ. (Graduate student), 2. Hirosaki Univ. (Present: JX Advanced Metals Corporation, Limited.), 3. Hirosaki Univ.)
[P168]Numerical estimation of critical resolved shear stresses in as-cast Mg94Zn2Y4 alloy
*DAICHI TANAKA1, TSUYOSHI MAYAMA1, SHUNTARO TAKAYAMA1, MICHIAKI YAMASAKI2, SATOSHI MOROOKA3, WU GONG3, STEFANUS HARJO3, KOJI HAGIHARA4, TOKO TOKUNAGA4 (1. Graduate School, Kumamoto Univ., 2. Magnesium Research Center, Kumamoto Univ., 3. JAEA, 4. Nagoya Institute of Tech.)
[P169]Effect of lithium addition on three-point bending deformation behavior of magnesium single crystals
*Kanta NOJIRI1, Hiromoto KITAHARA2, Shinji ANDO2 (1. Kumamoto University, 2. Kumamoto University / MRC)
[P171]Study of the activation of the non-basal slip systems by dislocation re-combination during creep deformation of Mg-0.87%Y-0.02%Zn alloy
*Koudai YAMAMOTO1, Mayumi SUZUKI2 (1. Graduate Student, Toyama Prefectural University, 2. Toyama Prefectural University)
[P172]Persistent slip in a Ti-22V alloy
*Haruki TANOUE1, Tatsuya MORIKAWA2, Shigeto YAMASAKI2, Masaki TANAKA2 (1. Graduate Student,Kyushu University, 2. Kyushu University)
[P173]Effect of microstructure on mechanical properties of Ti–4Fe–xCu–1.5Al alloys
*Yoshiki KIMURA1, Takahisa SHIRAISHI2, Takanori KIGUCHI2 (1. Kumamoto Univ (master), 2. Kumamoto Univ MRC)
[P174]Mechanical property and microstructure observation of Al-based CeNF/Al composite fabricated with Al filter
清水元陽*1, 李 昇原2, 土屋大樹2, 池野 進3, 松田健二2 (1.富山大(院生)、2.富山大、3.富山大名誉教授)