Presentation Information

[Material-01]AFM Elastic Modulus Mapping-Based Fundamental Study of Structure–Physical Property Correlations in Asphalt

*Miyu Fukaya1, Ryotaro Shimizu1, Toshiaki Hirato1 (1. Research Laboratory, Toa Road Corporation (Japan))

Keywords:

AFM,Force mapping,Colloids,Asphalt,Bee structures

It is well known that asphalt hardens and loses ductility with aging deterioration. The primary cause is considered to be the increase in asphaltene content due to oxidation and ultraviolet radiation effects, and the accompanying structural changes. To understand these chemical changes, conventional methods such as compositional analysis by thin-layer chromatography and evaluation of carbonyl group content by infrared spectroscopy have been employed. However, these analyses alone have not sufficiently clarified the correlation between structural changes and physical properties, particularly failing to capture the correspondence between structural changes and penetration. Additionally, Japan has a high application rate of recycled asphalt mixtures, and studies on recycling modified asphalt have become increasingly active. Therefore, to explore appropriate recovery methods, techniques are required that can comprehensively understand changes in asphalt structure and physical properties.
In recent years, scanning observation of micro-regions using Atomic Force Microscopy (AFM) has been advanced, enabling the acquisition of microstructure images of colloidal asphalt that were difficult to obtain with electron microscopy or optical microscopy. Consequently, numerous studies have focused on changes in the Bee structures present in asphalt.
We focused on AFM capable of acquiring elastic modulus mapping and attempted to elucidate the correlation between asphalt composition and physical properties. This is an effective method that is more quantitative compared to the conventional qualitative analysis of viscoelastic properties using phase images, and can measure intrinsic material properties rather than surface conditions.
In this study, AFM observations indicated that high and low elastic regions in asphalt could be distinguished in detail. The Bee structures present at the center of high elastic regions consisted of components with different elastic modulus, which was consistent with previous studies. Furthermore, we demonstrated that the dispersion state of polymers in polymer-modified asphalt can also be clearly observed.
We have identified a method that can clearly reveal changes in the structure and physical properties of asphalt through AFM elastic modulus mapping. This approach is expected to enable quantitative analysis of macroscopic property changes caused by compositional changes in asphalt from the perspective of microstructure.