Presentation Information

[t3FRZuAM-01]Development of an Algorithm Based on Residual Deicing Salt on Road Surfaces

*jang daeseong1, Lim chisu1, Kwon Ohsun2, Lee Jongsub2, Lee Jaejun1 (1. Jeonbuk National University (Korea), 2. Korea Expressway Corporation Research Institute (Korea))

Keywords:

winter,chloride-based agents,reapplication of deicing agents

In winter, precipitation such as freezing rain or snow may melt due to the application of deicing agents but remain on the road surface and refreeze at low temperatures, thereby increasing the risk of traffic accidents. To prevent such freezing-related accidents, extensive winter road maintenance is required, which currently demands substantial resources, including snow removal vehicles and manpower. However, the use of chloride-based deicing agents is inevitable for effectively removing ice or snow from road surfaces. According to the “Guidelines for Road Snow Removal Operations,” deicing agents are not applied only once; rather, reapplication is required when the road surface remains wet for more than three hours under low-temperature conditions (below 4 °C) or when severe weather conditions such as snowfall or freezing rain persist. Nevertheless, in Korea, the criteria for reapplication are currently determined in a simplified manner, based on research conducted by the University of Nebraska, which reported that melted snow refreezes within approximately 2–3 hours. In addition, the reapplication amount is often set equal to the initial application without clear scientific justification or is determined based on the subjective judgment of on-site supervisors. Therefore, there is a pressing need to establish accurate and objective standards for the timing and quantity of deicing agent reapplication. Accordingly, to develop an algorithm based on residual saline content on road surfaces, six target sites were selected for field measurements. Residual saline content was measured across different road surface positions on the road surface, including the shoulder, wheel paths, and lane center. To minimize the influence of other variables, measurements were conducted separately for each road position. To identify factors affecting residual saline content, meteorological data were collected using a compact RWIS during the measurement periods. The RWIS sensors were installed directly on the road surface to accurately capture road condition data. Traffic-related variables, including vehicle counts and travel speeds, were recorded using a speed gun and visual observation. Residual saline content was measured using a mobile salinity measurement device. After collecting environmental and meteorological data along with residual salt content data, regression analysis was conducted for algorithm development. Owing to physical limitations in acquiring residual salt data by lateral road position, the dataset was divided into 12 subsets based on individual reapplication events. For each dataset, correlation analyses were performed using SPSS to examine relationships between residual salt content and weather and environmental factors. Significant influencing factors were selected based on correlation coefficients (R) and p-values, and corresponding regression models and equations were subsequently developed. Finally, an overall regression model was derived, and its goodness of fit was evaluated to verify the model performance.