Session Details

Research activity on the cooling model for the run-out table in the hot strip mill

Thu. Sep 19, 2024 10:00 AM - 5:15 PM JST
Thu. Sep 19, 2024 1:00 AM - 8:15 AM UTC
Room7(CELAS Lecture Bldg. C 3F, C307)
永井二郎 [福井大]、芹澤良洋 [日本製鉄]

[D18]Experimental study of rapid cooling technology

○Yoshihiro Serizawa (Nippon Steel)

[D19]Construction of heat treatment analysis model considering transformation plasticity and accuracy verification

○Takuya Fujisawa (JFE)

[D20]Model identification for coiling temperature control by optimization method

○Hiroyuki Imanari, Kazuhiro Ohara, Kazutoshi Kitagho (TMEIC)

[D21]Spray cooling of high-temperature surfaces under controlled environmental conditions

○Masamichi Kohno1, Sumitomo Hidaka1, Yasuyuki Takata1, Yutaku Kita2 (1.Kyushu Univ., 2.KCL)

[D22]Evaluation method of surface heat flux in water jet impingement on a moving hot body based on exact solution of heat conduction equation

○Takato Yamamoto, Hitoshi Fujimoto (Kyoto Univ.)

[D23]Observation of morphology of voids in oxide scale formed on steel plate and evaluation of its effect on cooling

○Kentaro Kuwahara1, Rie Endo1, Ondrej Resl2 (1.Shibaura Inst. of Tech., 2.Brno Univ. of Tech.)

[D24]Revised method on inverse heat conduction and boiling heat transfer characteristics in spray cooling system with surface oxide film

○Niro Nagai, Yuto Nishi (Univ. of Fukui)

[D25]Progress in an experimental study on laminar cooling heat transfer characteristics of ROT with hot rotating hollow cylinder quenching tests

○Yuichi Mitsutake, Yuhtaro Hirahara, Syunsuke Murakami, Masanori Monde (Saga Univ.)

[D26]Characteristics of quenching sphere covered with thin film of Teflon into LN2

○Masanori Monde, Yuhichi Mitsutake (Saga Univ.)