講演情報
[Recycle-21]Theoretical and Empirical Approaches to Construction Time Reduction Using Warm-Mix Asphalt
*Hiroshi Iwabuki1, Haruki Aoyama1, Mitsuru Yoshida2, Yasuhide Takahama2 (1. Central Nippon Expressway Company Limited (Japan), 2. NIPPO CORPORATION (Japan))
キーワード:
Warm-Mix Asphalt (WMA)、Construction Time Reduction、Curing Time Reduction、Newton's Law of Cooling、Highway Pavement、Lane Closure、Hot-Mix Asphalt (HMA)
This paper addresses the critical challenge of reducing construction and lane closure times during highway pavement repairs, a pressing issue in Japan due to increasing traffic volumes and aging expressways. The authors investigate the use of warm-mix asphalt (WMA) mixtures, which are produced and applied at temperatures approximately 20°C lower than conventional hot-mix asphalt (HMA). The primary goal is to shorten the curing time required before reopening lanes, thereby minimizing traffic disruption. A field trial was conducted on the renewal section of the Tomei Expressway, comparing conventional asphalt mixtures with warm-mix asphalt under equivalent conditions. In this trial, WMA was applied to the base and upper base layers, while conventional mixtures were used on the driving lane. Temperature sensors embedded at the center height of each pavement layer recorded internal temperature changes during and after paving to evaluate the cooling and curing process. The results demonstrated that the curing time for WMA was significantly shorter than for conventional mixtures. For the base layer in two-layer construction, the curing time was reduced by 92 minutes. In three-layer construction involving both the base and upper base layers, the total curing time reduction exceeded three hours. These findings indicate that thicker pavement layers experience greater time savings when using the warm-mix approach. To quantitatively analyze the temperature drop, the study applied Newton’s law of cooling (a principle describing the rate of temperature change), modeling the asphalt temperature decay as an exponential function. The model closely matched the measured temperature data, with correlation coefficients above 0.98, confirming the validity of this approach for predicting curing times. In conclusion, the use of warm-mix asphalt mixtures effectively reduces curing times and shortens lane closure durations, contributing to decreased traffic congestion and accident risks during highway maintenance. Future work will focus on extending the application to surface layers and refining predictive models for thinner layers to further optimize construction scheduling.
