講演情報
[flK2f1Kp-09]Rutting Performance of Asphalt Pavements: A Combined Study on Mixture Performance and Bitumen Rheological Behaviour
Luca Colombo1, Michel Di Tommaso2, Vito Giovanni Gallo2, Giuseppe Macaluso2, Carmine Rizzato2, Misagh Ketabdari1, *Emanuele Toraldo1 (1. Politecnico di Milano, Department of Civil and Environmental Engineering (DICA) (Italy), 2. IMM SA – Istituto Meccanica dei Materiali SA, Via al Molino 55, CH – 6926 Montagnola (Switzerland))
キーワード:
Rutting、Creep、Wheel tracking、Uniaxial cyclic compression、Rheological characterization
Rutting is among the most critical distresses affecting the long-term performance of bituminous pavements, primarily driven by higher service temperatures and often accelerated by increased traffic loads. It is also a key distress mechanism expected to worsen under the influence of the climate change. This study evaluates the rutting susceptibility of four plant-produced asphalt mixtures: a wearing course, a binder layer, a base layer, and a sub-base layer. The research links conventional volumetric characterization with an extended laboratory program to quantify permanent strain accumulation and thermal sensitivity, and to compare the coherence of different test methods.Specimens are prepared with strict control of volumetric properties using roller compaction and gyratory compaction as required by the relevant EN standards. Two main mechanical tests were carried out at high servise temperature: the Wheel Tracking (EN 12697-22) and the Uniaxial Cyclic Compression test (EN 12697-25-A1). From these tests the rutting curves are obtained as well as creep-related metrics (creep deformation, compliance, modulus and rate) for direct comparison.Complementary rheological characterization of recovered binders (EN 12697-3) included T-SWEEP (DSR) and MSCR tests to obtain complex modulus, phase angle, non-recoverable creep compliance (Jnr) and percent recovery (R) over a range of temperatures. The combined dataset highlights clear differences in temperature sensitivity and rutting tendency among mixtures and demonstrates overall consistency between rheological indicators and mechanical accumulation of permanent strain. These outcomes contribute to improving the mechanistic understanding of rutting phenomena. The experimental database produced here provides a traceable foundation for predictive model development that can be used for mix design and quality control purposes. Future work will focus on correlating laboratory results with in-service rut depths prediction, extending the test matrix (e.g., triaxial cyclic compression).
