講演情報
[Recycle-24]Laboratory experiments to Characterize Mixture Properties for Establishing a Mix Design Method for Recycled Polymer Modified Asphalt Mixtures
*Shota Kobayashi1, Naoto Yokozawa1, Atsushi Kawakami1, Kazuhiro Watanabe1, Satoshi Sagawa2 (1. Public Works Research Institute (Japan), 2. JAPAN ASPHALT MIXTURE ASSOCIATION (Japan))
キーワード:
Recycling、Polymer Modified Asphalt、Recycled Mixture、Mix Design
The recycling rate of pavement waste materials in Japan is close to 100%, and it is necessary to maintain this high level in the future. Polymer modified asphalt mixtures are often used on heavy traffic roads, however standard mix design and evaluation methods for recycled mixtures using modified asphalt (hereafter recycled polymer modified asphalt mixtures) have not yet been established. Currently, recycled polymer modified asphalt mixtures account for approximately 15% of all polymer modified asphalt mixtures, however if standards, evaluation methods, and mix design techniques for recycled polymer modified asphalt mixtures are established, it is expected that recycling will be further promoted.
This study aimed to establish a mix design method for recycled polymer modified asphalt mixtures. Laboratory tests were conducted on mixtures differing in the asphalt used, the presence or absence of rejuvenator, and supplementary modifiers. These tests evaluated fundamental mixture properties and those related to long-term serviceability, specifically crack resistance and fatigue resistance.
Laboratory tests showed that without the use of regenerating additives, the mixture hardened and its rutting resistance improved, but its crack resistance decreased.
Under mixing conditions where only the rejuvenator was used, the mixture properties did not recover and were inferior to those of the new mixture. Although the basic mixture properties met the standard values, fatigue resistance and crack resistance were reduced.
By supplementing the deficient modifier, rutting resistance and crack resistance can be restored to levels equivalent to the new mixture. However, regarding fatigue resistance, while the four-point bending fatigue test yielded a failure cycle count equivalent to the new modification, the indirect tensile fatigue test produced results inferior to the new mixture.
In the future, we plan to verify the relationship between performance on actual roads and the results of indoor experiments, and to proceed with establishing a mix design method.
This study aimed to establish a mix design method for recycled polymer modified asphalt mixtures. Laboratory tests were conducted on mixtures differing in the asphalt used, the presence or absence of rejuvenator, and supplementary modifiers. These tests evaluated fundamental mixture properties and those related to long-term serviceability, specifically crack resistance and fatigue resistance.
Laboratory tests showed that without the use of regenerating additives, the mixture hardened and its rutting resistance improved, but its crack resistance decreased.
Under mixing conditions where only the rejuvenator was used, the mixture properties did not recover and were inferior to those of the new mixture. Although the basic mixture properties met the standard values, fatigue resistance and crack resistance were reduced.
By supplementing the deficient modifier, rutting resistance and crack resistance can be restored to levels equivalent to the new mixture. However, regarding fatigue resistance, while the four-point bending fatigue test yielded a failure cycle count equivalent to the new modification, the indirect tensile fatigue test produced results inferior to the new mixture.
In the future, we plan to verify the relationship between performance on actual roads and the results of indoor experiments, and to proceed with establishing a mix design method.
