講演情報
[Data_Collection-27]Development of a 3D Camera and IoT-Based System for Identifying Defective Ground
*Youhei Tachibana1, Tsubasa Komasaka1, Hisashi Aita1 (1. NIPPO Corporation (Japan))
キーワード:
proof rolling、3D camera、subgrade and subbase
Many cracks and damages that occur in asphalt pavement are often caused by insufficient bearing capacity or weakening of the subgrade or base layers. In recent years, to improve the durability and longevity of pavement, there have been many cases where the base or lower layers of the pavement are reinforced. The subgrade and base are crucial layers when considering pavement durability, and quality control in these layers must be thoroughly conducted.
One quality control test for subgrade and base is proof rolling. In this method, a test vehicle is driven over the finished subgrade or base, and inspectors visually check for deformation caused by the load, determining pass or fail. This test has been conducted in much the same way for over 60 years. The advantages of this method are that no special equipment is required, it can be performed immediately, and results can be determined in real time without calculations. However, there are issues such as reliance on human judgment, the need for multiple inspectors to prevent oversight of deformations, physical burden on inspectors, and safety risks due to working near vehicles.
To solve these problems, a new system utilizing digital devices has been developed. A 3D camera is installed near the tires of the test vehicle to measure and analyze ground deformation as the vehicle passes, enabling automatic and real-time pass/fail judgment. The analysis results are uploaded to the cloud in real time and can be checked as a heat map via a dedicated app. This system eliminates the previous issues of human-dependent judgment and missed deformations, while also improving efficiency and safety. It also enables remote confirmation, bringing innovation to this testing process.
One quality control test for subgrade and base is proof rolling. In this method, a test vehicle is driven over the finished subgrade or base, and inspectors visually check for deformation caused by the load, determining pass or fail. This test has been conducted in much the same way for over 60 years. The advantages of this method are that no special equipment is required, it can be performed immediately, and results can be determined in real time without calculations. However, there are issues such as reliance on human judgment, the need for multiple inspectors to prevent oversight of deformations, physical burden on inspectors, and safety risks due to working near vehicles.
To solve these problems, a new system utilizing digital devices has been developed. A 3D camera is installed near the tires of the test vehicle to measure and analyze ground deformation as the vehicle passes, enabling automatic and real-time pass/fail judgment. The analysis results are uploaded to the cloud in real time and can be checked as a heat map via a dedicated app. This system eliminates the previous issues of human-dependent judgment and missed deformations, while also improving efficiency and safety. It also enables remote confirmation, bringing innovation to this testing process.
