講演情報
[t3FRZuAM-04]Compaction of the asphalt layers
*Damjan Zore1, Blaž Jeraj1, Nina Kepic1 (1. slovenian (Slovenia))
キーワード:
temperature segregation、asphalt compaction、asphalt mixture
Asphalt has been used by humans for over seven thousand years and is one of the most commonly used building material. Weaknesses can be found everywhere, and asphalt is no exception. One of its major drawbacks is that it cannot be compacted when it gets too cold.
The asphalt mixture begins to cool as soon as it is loaded onto a truck. During transport, the mixture cools very quickly on the surface, causing to form a crust with a significantly lower temperature than it is in the core. The longer the transport takes, the thicker and colder the crust gets. Figure 1 shows asphalt mixture on the truck at the moment of tipping into the asphalt paver. The difference in temperature of the crust and the center is clearly visible.
According to the classical form of the pile (on the truck), areas with varying degrees of temperature segregation usually appear.- Low segregation rate is in area B (Figure 2), approximately in the middle of the caisson with the largest proportion of core, which successfully retains the temperature of the produced mixture.- High levels of segregation are found in areas A and C (Figure 2), where the core ratio is significantly lower, resulting in greater temperature loss (lowering) and cooler mixture.
At the start of unloading (lifting the dump truck caisson), the paver hopper is first filled with mix from area C (colder mix). The following is a mixture from area B, with the highest (preserved) temperature. At the end of unloading (emptying the caisson), the container is filled with a mixture from area A (again a cooler mixture). After the truck change, the mixture from area C is added again. Thus, during the truck change, the mixture in the finisher's hopper is combined from areas A and C, which represents a larger amount of a significantly cooler mixture. During truck changes, the paver usually stops and during the stop, area D (Figure 3) cannot be compacted because the rollers cannot reach it. Area D is exposed to two negative influences, so the layer in this area has the lowest temperature and is consequently the least compacted.
The asphalt mixture begins to cool as soon as it is loaded onto a truck. During transport, the mixture cools very quickly on the surface, causing to form a crust with a significantly lower temperature than it is in the core. The longer the transport takes, the thicker and colder the crust gets. Figure 1 shows asphalt mixture on the truck at the moment of tipping into the asphalt paver. The difference in temperature of the crust and the center is clearly visible.
According to the classical form of the pile (on the truck), areas with varying degrees of temperature segregation usually appear.- Low segregation rate is in area B (Figure 2), approximately in the middle of the caisson with the largest proportion of core, which successfully retains the temperature of the produced mixture.- High levels of segregation are found in areas A and C (Figure 2), where the core ratio is significantly lower, resulting in greater temperature loss (lowering) and cooler mixture.
At the start of unloading (lifting the dump truck caisson), the paver hopper is first filled with mix from area C (colder mix). The following is a mixture from area B, with the highest (preserved) temperature. At the end of unloading (emptying the caisson), the container is filled with a mixture from area A (again a cooler mixture). After the truck change, the mixture from area C is added again. Thus, during the truck change, the mixture in the finisher's hopper is combined from areas A and C, which represents a larger amount of a significantly cooler mixture. During truck changes, the paver usually stops and during the stop, area D (Figure 3) cannot be compacted because the rollers cannot reach it. Area D is exposed to two negative influences, so the layer in this area has the lowest temperature and is consequently the least compacted.
