Session Details
[P]P202~P216 Mechanical Properties of Materials
Wed. Sep 23, 2026 3:30 PM - 5:00 PM JST
Wed. Sep 23, 2026 6:30 AM - 8:00 AM UTC
Wed. Sep 23, 2026 6:30 AM - 8:00 AM UTC
Poster Session Room(Small Gymnasium)
[P202]Effect of microstructure formation on the deformation in Ti–Cr alloys
○Ryosuke Matsumoto1, Masakazu Tane1 (1. The University of Osaka)
[P203]In-Situ Observation of Twin Nucleation and Propagation in Pure Magnesium by AE-Driven High-Speed Imaging
○Jingming Song1, Takayuki shiraiwa1 (1. The University of Tokyo)
[P204]Control of microstructure and mechanical properties of CoNiTi-based multicomponent alloys through alloy composition optimization
○Kenta Asamura1, Toko Tokunaga1, Koji Hagihara1 (1. Nagoya Institute of Technology)
[P205]Effects of P and B on the Yield Strength of Si Single Crystals
○Taiki Kusano1, Tatsuya Morikawa1, Shigeto Yamasaki1, Masaki Tanaka1, Jun Fujise2, Toshiaki Ono2 (1. Kyushu University, 2. SUMCO Corporation)
[P206]Effect of Pitting Corrosion on Fatigue Fracture in A7150 Aluminum Alloy
○Kaisei Ito1, Ken Takata1, Kazushige Tokuno1, Eiji Tadokoro1 (1. Daido University)
[P207]Effects of tensile axis orientation on nonbasal slips in zinc single crystals
○Shunsuke Sasaki1, Ryota Nino1, Hiroki Kitahara1, Shinji Ando1 (1. Kumamoto university)
[P208]Dynamic evolution of deformation mechanism and microstructure in superplastic behaviorof coarse-grained Mg-14Li-5Zn alloy
○Yuki Murakami1, Kouya Kyan1, Takahiro Mineta1 (1. Hirosaki Univ.)
[P209]The Effect of Al Addition on the Heat Treatment Temperature of Creep Resistance in Duplex Mg-Li-Based Alloys
○Yamato Shimizu1, Takahiro Mineta1 (1. Hirosaki Univ.)
[P210]Mn concentration and grain size dependence of creep and
dynamic recrystallization behavior of CrMnFeCoNi alloys
○Hayato Maruyama1, Hiroyuki Sato1, Takahiro Mineta1 (1. Hirosaki University)
[P211]Mechanical Properties and Strengthening Mechanisms of Mg-Li-Al Alloy/Zn Clad Materials
○Daisuke Maruyama1, Takahiro Mineta1 (1. Hirosaki University)
[P212]Inhomogeneous Strain Evolution Associated with Dislocation Microstructures Formed during Cyclic Deformation of an SUS316L Stainless Steel
○Yuyang Bai1, Tianchang Ma1, Sukyoung Hwang1, Toshiyuki Fujii1 (1. Institute of Science Tokyo)
[P213]In situ TEM/ HVEM Observation of Dislocation Behavior in Molybdenum
○Daichi Ueda1, Takahito Inoue1, Yasuko Ueda2, Satoshi Ichikawa3, kazuto Arakawa2,3 (1. Graduate School of Natural Science and Technology, Shimane University, 2. Next Generation Tatara Co-Creation Centre (NEXTA), Shimane University, 3. Research Center for Ultra-High Voltage Electron Microscopy, Osaka University)
[P214]Evaluation of Fatigue Crack Initiation Scatter in Pure Titanium Using Diffusion-Model-Based Microstructure Generation and CPFEM
○Shohei Yachi1, Takayuki Shiraiwa1 (1. Tokyo Univ.)
[P215]Analysis of microstructural changes associated with deformation in Ni-Mn-Ga particles obtained by mechanical milling
○Tasuku Fujino1, Naoki Nohira1, Aya Harashima1, Wan-Ting Chiu2, Masaki Tahara1, Volodymyr Chernenko3, Hideki Hosoda1 (1. IIR Science Tokyo, 2. SMCT Science Tokyo, 3. BCMaterials)
[P216]Evaluation of Young’s Modulus and Internal Friction of Solar Cell Materials by the Free–Free Flexural Vibration Method
○Tomoya Matsuoka1, naoki ide1, youichi nishino (1. Nagoya Institute of Technology)