Session Details

[P]P83~P111

Wed. Sep 17, 2025 1:30 PM - 3:00 PM JST
Wed. Sep 17, 2025 4:30 AM - 6:00 AM UTC
Global Research Center for Food & Medical Innovation(P83~P111, P269~P297)

[P83]High temperature oxidation behavior of low activation high entropy alloy in air

*Ryo Hashimoto1, Naoki Nishiyama1, Yuki Nakagawa2, Eiichi Wakai3,4, Tamaki Shibayama2 (1. Grad. Sch. of Eng., Hokkaido Univ, 2. Faculty of Eng. Hokkaido Univ, 3. JAEA, 4. Michigan State Univ)
Comment()

[P84]Analysis of the effect of heat treatment on the corrosion behavior of Mg-9Li-4Al-1Zn alloy

*Shiqi Jia3, Masashi Nishimoto1, Mineta Takahiro2, Izumi Muto1 (1. Tohoku Uni., 2. Hirosaki Uni., 3. Tohoku Uni. (student))
Comment()

[P85]Investigation of Ni Solubility in the MgZn2 Phase for the Neutralization of Impurity Elements in Mg Alloys

*Naoki KADOTA1, Kaito URUCHIDA1, Taiki MORISHIGE2 (1. Graduate School of Science and Engineering, Kansai University, 2. Kansai University)
Comment()

[P86]The effect of Cr, Mn distribution on the pitting corrosion resistance of Cantor alloy

*Miho Shigenaka1, Kensuke Misawa1 (1. NIPPON STEEL)
Comment()

[P87]Investigation of the effect of ultra-fine bubbles on the inhibition of crevice corrosion on stainless steels

*Miri YANO1,2, Yusuke TSUTSUMI1, Takaya AKASHI2, Hideki KATAYAMA1 (1. National Institute for Materials Science, 2. Hosei University)
Comment()

[P88]Relationship between pitting resistance and amount of desorbing H2O for Ni passive film treated with film modification treatment

*Naoya Kanatani1, Kaisei Tanabe1, Youhei Hirohata2, Takumi Haruna2 (1. Kansai Univ., 2. Kansai Univ.)
Comment()

[P89]Corrosion behavior of Type 304 stainless steel with introduced dissimilar phases by cold working

*Mitsutoshi MATSUMORI1, Yuta YAGI2, Kazuhiko NODA3, Yoshimi WATANABE4 (1. Shibaura Institute of Technology Graduate School, 2. Nakabohtec Corrosion Protecting CO., LTD., 3. Shibaura Institute of Technology, 4. Nagoya Institute of Technology)
Comment()

[P90]Influence of Al concentration on the polarization behavior of metal surface without oxide film in AZ series Mg alloys

*Yayoi Niimiya1,2, Sachiko Hiromoto2,3, Tomoyuki Yamamoto3 (1. Waseda Univ., 2. National Institute for Materials Science, 3. Waseda Univ.)
Comment()

[P91]Graphene Oxide Film on Mg Alloy Surface and Its Evaluation

*Wataru Sakamoto1,2,3 (1. Tokyo denki university engineering department(master), 2. Tokyo denki university engineering department(associate Professor), 3. Tokyo denki university engineering department(bachelor))
Comment()

[P92]Evaluation of Corrosion Resistance of Stainless Steel
by AC Impedance Measurement Using a Sensor

*Mizuki IMAI1, Keigo HATTA1, Yuta YAGI2, Kazuhiko NODA3, Hideki KATAYAMA4 (1. Shibaura Institute of Technology Graduate School, 2. Nakabohtec Corrosion Protecting Co., Ltd., 3. Shibaura Institute of Technology, 4. National Institute for Materials Science)
Comment()

[P93]Corrosion prevention effect of Zinc-Rich Paint

*JUNQING BAO1, Ryouji SUZUKI1,2, Yuta YAGI1,3, Kazuhiko NODA1 (1. Faculty of Engineering, Shibaura Institute of Technology, 2. Japan Power Engineering and Inspection Corporation, 3. Nakabohtec Corrosion Protecting Co., LTD)
Comment()

[P94]Corrosion Resistance Evaluation of Zinc-based Coated Steel Sheets

*Kei MOROOKA1, Keigo HATTA1, Yuta YAGI2, Kazuhiko NODA3 (1. Shibaura Institute of Technology Graduate School, 2. Nakabohtec Corrosion Protecting Co., Ltd., 3. Shibaura Institute of Technology)
Comment()

[P95]Characterization of Ti-Ca Films Fabricated by RF Magnetron Sputtering

*Kodai NAKAMURA1, Yuki Otani2, Naoki Takata1, Hiroki Akasaka3, Junko Hieda1 (1. Nagoya Univ., 2. Univ. of Hyogo, 3. Science Tokyo)
Comment()

[P96]Optical Characterization of Microstructured CuO Thin Films Prepared By Glancing-angle Reactive Sputtering

Yamato SAKAMOTO1, *Kazusa OZAWA2, Yasushi INOUE1,2, Osamu TAKAI3 (1. Grad. Eng., Chiba Inst. Technol, 2. Sch. Eng., Chiba Inst.Technol, 3. SSAME)
Comment()

[P97]Surface modification by plasma nitriding using Cr-Mo combination screen

*Kosei Sakamoto1, Yasuhiro Hoshiyama2, Tomoki Maruoka3 (1. 関西大学(院生)、2. 関西大学、3. 京都市産業技術研究所)
Comment()

[P98]Effect of screen wire diameter on plasma nitriding using Ti-Al combination screen

*Yu NAKATSUKA1, Yasuhiro Hoshiyama2, Tomoki Maruoka3 (1. 関西大学(院生)、2. 関西大学、3. 京都市産業技術研究所)
Comment()

[P99]Effect of Deposition Temperature on the Electrochromic Properties of InN Thin Films Prepared by Glancing-angle Deposition

Sho Hirata1, *Taisei Ushiki1, Yasushi Inoue1, Osamu Takai2 (1. Sch. Eng., Chiba Inst. Technol., 2. SSAME)
Comment()

[P100]Surface Planarization of Metal Substrates and Pt Film Growth for the Development of Vibration Energy Harvesters

*Ririka IZUMI1, Masaki NAKANO1, Hiroyuki OGUCHI1 (1. Shibaura Institution of Technology)
Comment()

[P101]Fabrication and Subsequent Lift-Off of Through-Hole Porous Alumina
via Low Current Electrochemical Method

*Takumi Koguchi1, Hagiwara Yoshiya1, Miyamoto Masayuki2, Kikuchi Tatsuya2 (1. 北大工(院生)、2. 北大工)
Comment()

[P102]Dyeing Properties and Lightfastness of Anodised Aluminum Films Using 18 Natural Dyes

*Naoki AKAGAWA1, Hitoyuki TANAKA1, Daisuke NAKAGAWA1, Yoshitsugu KAMIMURA2, Nanoka YAMAMOTO2, Takanori MATSUBARA2 (1. College of Industrial Technology, 2. College of Industrial Technology)
Comment()

[P103]Hydrogen evolution reaction of the cobalt-supported tungsten carbide catalyst

*Koichi MATSUDA1, Yamamoto Hiroaki2, Nozaki Ai2, Ueno Tomoyuki3, Yanagita Hidefumi3 (1. University of Hyogo Graduate Student, 2. University of Hyogo, 3. Sanalloy Industry)
Comment()

[P104]Influence of trace amounts of Fe ions on precious metal hydrogen evolution catalysts

*Fumiharu KUSAKA1, Naoto TODOROKI1 (1. Tohoku Univ.)
Comment()

[P105]Dependence of thermal annealing temperature of Pt/CrMnCoNiPd/Pt(hkl) surfaces on oxygen reduction reaction properties

*Arata Umehara1, Yoshihiro Chida2, Todoroki Naoto1, Wadayama Toshimasa1 (1. Tohoku University, 2. AIST)
Comment()

[P106]Influence of surface atomic arrangement on the stability of IrO2 single crystal thin film model electrodes under potential loading

*Yuto OKAOKAYAMA1, Tomohiro Yoshinaga1, Naomi Naraki1, Naoto Todoroki1 (1. Tohoku Univ.)
Comment()

[P107]Soft X-ray absorption spectroscopy of Ni electrodes used for SOFC after NH3 decomposition reaction

*YUSHI SUMIDA1,4, Haruki Ishida2, Yuske Fukui1,4, Koji Nakanishi3, Athushi Mineshige1, Toshiaki Mathui2, Takuo Ohkochi3,4,5 (1. Grad. Sch. Eng., U. Hyogo, 2. Grad. Sch. Eng., Kyoto Univ., 3. LASTI, U. Hyogo, 4. RIKEN SPring-8 Center, 5. JASRI)
Comment()

[P108]Catalysis of absorbed hydrogen in Zr7Ni10 hydrogen storage alloy

*Shu Mizutome1, Kouji Sakaki2, Kohta Asano2, Ya Xu3, Satoshi Kameoka4 (1. Tohoku Univ., 2. AIST, 3. NIMS, 4. IMRAM, Tohoku Univ.)
Comment()

[P109]Effects of In, Sn, and Sb on propyne hydrogenation properties of Heusler alloy catalysts

*Yuki IDA1, Takayuki KOJIMA2 (1. 信州大繊維(院生)、2. 信州大繊維)
Comment()

[P110]High-Entropy Alloying Heusler Catalysts and Selective Hydrogenation of Propyne

*Kei YODA1, Takayuki KOJIMA2 (1. Faculty of Textile Science and Technology, Shinshu University (Graduate Student), 2. Faculty of Textile Science and Technology, Shinshu University)
Comment()

[P111]Cr Segregation at Tilt Grain Boundaries in Ni-Cr Alloy

*Jing Nong1,2, Qian Chen1, Kazutoshi Inoue1, Jian Xu2, Yuichi Ikuhara1,3,4 (1. WPI-AIMR, Tohoku Univ.、2. School of Materials, Sun Yat-sen Univ.、3. Inst. Engineering Innovation, The Univ. of Tokyo、4. JFCC)
Comment()